LAN Mode Connection Recent

1. OTG Dual-Mode Chassis

OTG dual-mode chassis supports both USB screen projection and network cable screen projection.

Setup Steps:

1. First set the chassis to USB connection mode
2. Connect the computer host with a USB cable and successfully project the screen
3. Use a network cable to connect the chassis to the router (must be the same router as the computer)
4. Find [OTG Settings] in the Panda window
5. Type in terminal: ipconfig - Enter the network gateway address. Click Add
6. After completion, click the [Enable] button. Default port is 5555 (generally no need to modify)
7. After clicking Start, manually switch the chassis to OTG mode
8. Click Scan and wait

Video Demonstration

2. WIFI/OTG Mode Unstable?

Solutions:

1. Router problem - Replace with an enterprise-level router
2. Too many devices on a router may cause signal interference - Build a soft router
3. Phone locked may cause WiFi disconnection

3. Mobile Phone Cannot Scan?

Solutions:

1. Is the router connected to the computer the same as the router connected to your chassis? If not, are the networks interoperable?
2. Is the chassis a dual-cut chassis (supports OTG and USB) or a non-cut chassis (supports OTG only)?
   • OTG chassis: Connect to Panda in USB mode first. After success, click to start port 5555, then manually switch to OTG mode, enter the network IP range (e.g., 192.168.1.1 to 192.168.1.255), click Add, then Scan.
   • Non-cut chassis: Directly enter the network IP and scan.